Body - Exterior A-Pillar Mouldings Loose
LTB00319NAS225 JAN 2012
ISSUE '2' CHANGES ARE HIGHLIGHTED IN GRAY
SECTION: 501
Exterior A-Pillar Molding Loose
AFFECTED VEHICLE RANGE:
CONDITION SUMMARY:
Situation:
The exterior A-pillar molding may become loose. This may be caused by the molding's retaining clips losing tension.
Action:
In the event of a customer concern of the above, refer to the Repair Procedure outlined below to install new A-pillar molding retaining clips.
PARTS:
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal Warranty policies and procedures apply
REPAIR PROCEDURE
INSTALL A-PILLAR RETAINING CLIPS
1. Refer to Workshop Manual, section 501-08: Exterior Trim and Ornamentation, and install the new A-pillar retaining clips to the A-pillar molding(s)
Disclaimer