Actuator: Service and Repair

Differential Locking Motor

Service Repair No - 51.15.03

Removal

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.





2. Remove the differential locking motor.
^ Disconnect the electrical connector.
^ Remove the 4 bolts.

Installation
1. Clean the component mating faces.





2. Apply continuous bead of sealant to the motor mating face on the differential.
3. Install the differential locking motor.
^ Tighten the bolts to 10 Nm (7 ft. lbs.).
^ Connect the electrical connector.
4. Lower the vehicle.
5. Using T4, calibrate a new differential locking motor.