Floor Console Upper Panel

Floor Console Upper Panel

Service Repair No - 76.25.11

Removal

1. Disconnect the battery ground cable.
2. Remove the floor console stowage compartment.
^ Open the floor console stowage compartment lid.
^ Remove the 2 screws.
^ Carefully release the 2 clips.
^ Disconnect the cigar lighter electrical connector.







3. CAUTION: Make sure damage does not occur to the vehicle trim when removing the centre console side finisher trim panel.

NOTE: Left-hand shown, right-hand similar.

Remove the center console LH side finisher trim panel.
^ Using a suitable tool, carefully release the 3 clips.







4. CAUTION: Make sure damage does not occur to the vehicle trim when removing the centre console side finisher trim panel.

Remove the center console RH side finisher trim panel.
^ Using a suitable tool, carefully release the 3 clips.

5. Remove the selector lever knob.
6. Remove the climate controlled seat switch trim panel.
^ Carefully release the 4 clips.
^ Remove the 2 front screws from the floor console upper panel.







7. Reposition the floor console upper panel.
^ Using a suitable tool, carefully release the 4 clips.
^ Remove the 4 screws.







8. Disconnect the parking brake switch electrical connector.







9. Remove the floor console upper panel.
^ Release the 3 wiring harness clips.
^ Disconnect the 3 electrical connectors.







10. NOTE: Do not disassemble further if the component is removed for access only

Remove the floor console cup holder.
^ Remove the 6 screws.







11. Remove the parking brake switch.
^ Remove the parking brake switch trim panel.
^ Remove the 2 screws.







12. Remove the upper floor console stowage compartment
^ Remove the 4 screws.







13. Remove the ride and handling optimization switch assembly.
^ Remove the 6 screws.







Installation

1. Install the ride and handling optimization switch assembly.
^ Install the 6 screws.

2. Install the upper floor console stowage compartment.
^ Install the 4 screws.

3. Install the parking brake switch.
^ Install the 2 screws.
^ Install the parking brake switch trim panel.

4. Install the floor console cup holder.
^ Install the 6 screws.

5. Install the floor console upper panel.
^ Connect the 3 electrical connectors.
^ Attach the 3 wiring harness clips.

6. Connect the parking brake switch electrical connector.
7. Reposition the floor console upper panel.
^ Secure the 4 clips.
^ Install the 4 screws.

8. Install the climate controlled seat switch trim panel.
^ Install the 2 front screws to the floor console upper panel.
^ Secure the 4 clips.

9. Install the selector lever knob.
10. Install the center console LH side finisher trim panel.
^ Secure the 3 clips.

11. Install the center console RH side finisher trim panel.
^ Secure the 3 clips.

12. Install the floor console stowage compartment.
^ Connect the cigar lighter electrical connector.
^ Secure the 2 clips.
^ Install the 2 screws.
^ Close the floor console stowage compartment lid.

13. Connect the battery ground cable.