Lumbar Assembly
Lumbar Assembly
Removal
WARNING:
^ Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^ Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^ The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^ The correct procedures must always be used when working on SRS components.
^ It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^ Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
^ Take extra care when handling SRS components.
1. Disconnect the battery ground cable.
2. Make the air bag supplemental restraint system (SRS) safe.
3. Remove the front seat backrest lower rear cover.
4. Reposition the front seat backrest heater and blower motor assembly.
^ Carefully release the 2 clips.
5. Reposition the front seat backrest heater and blower motor assembly duct.
^ Release the 2 clips.
6. Reposition the lumbar motor control valve.
^ Disconnect the 2 electrical connectors.
7. Remove the lumbar assembly.
^ Release the 2 retaining tangs.
Installation
1. NOTE: Make sure the lumbar assembly is installed to its original position.
Install the lumbar assembly.
^ Secure the 2 retaining tangs.
2. Reposition the lumbar motor control valve.
^ Connect the 2 electrical connectors.
3. Reposition the front seat backrest heater and blower motor assembly duct.
^ Secure the 2 clips.
4. Reposition the front seat backrest heater and blower motor assembly.
^ Secure the 2 clips.
5. Install the front seat backrest lower rear cover.
6. Connect the battery ground cable.