Horn: Service and Repair

Horn

Removal

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

1. Raise and support the vehicle.
2. Remove the horn access panel.
- Remove the 5 clips.
- Remove the 3 screws.







3. Remove the horn assembly.
- Remove the bolt.
- Disconnect the 2 electrical connectors.







NOTE: Do not disassemble further if the component is removed for access only.

4. Remove the 2 horns from the mounting bracket.
- Remove the 2 nuts.

Installation
1. Install the 2 horns to the mounting bracket.
- Tighten the 2 nuts to 10 Nm (7 lb.ft).

2. Install the horn assembly.
- Connect the 2 electrical connectors.
- Install the bolt and tighten to 10 Nm (7 lb.ft).

3. Install the horn access panel.