Rear Wheel Speed Sensor
Rear Wheel Speed SensorService Repair No - 70.65.31
Removal
1. Raise and support the vehicle.
2. Remove the wheel and tire.
3. Release the wheel arch liner.
^ Remove the 5 screws.
4. Disconnect the rear wheel speed sensor electrical connector.
^ Open the electrical connector housing.
^ Release the electrical connector from the clip.
5. Remove the rear wheel speed sensor.
^ Release the wiring harness from the 5 clips.
^ Remove the bolt.
Installation
1. Install the rear wheel speed sensor.
^ Apply anti-seize compound to the ABS sensor.
^ Secure the wiring harness in the clips.
^ Tighten the bolt to 8 Nm (6 ft. lbs.).
2. Connect the wheel speed sensor electrical connector.
^ Secure the electrical connector clip.
^ Close the electrical connector housing.
3. Secure the wheel arch liner.
^ Tighten the screws.
4. Install the wheel and tire.
^ Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
5. Using the approved Land Rover diagnostic system, clear the fault codes from the ABS ECU.