Blower Motor: Service and Repair

Blower Motor
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures

Removal

NOTE:
The recirculation blend door must be closed in order for the removal of the recirculation blend door housing.
1 Activate recirculation.
2 Disconnect the battery ground cable.
For additional information, refer to Specifications [1][2]Specifications
3 Remove the accelerator pedal assembly.
For additional information, refer to Accelerator Pedal Service and Repair





4 Remove the glove compartment.
For additional information, refer to Glove Compartment Service and Repair
























5 Remove the CJB bracket.












6 Install the special tool guide to the blower motor.
Special Service Tool




Remover/Installer, Blower Motor, 412-140




7 With the marking upwards, use the guide to install the remainder of the special tool to the blower motor.
Special Service Tool




Remover/Installer, Blower Motor, 412-140





CAUTION: Make sure that the special tool is correctly located.
Rotate the special tool counter-clockwise to release the blower motor assembly.
Special Service Tool




Remover/Installer, Blower Motor, 412-140
Remove the blower motor assembly.
Release the blower motor locking tang.

Installation





1 Using the special tool, install the blower motor assembly approximately 10 degrees counter-clockwise from the vertical position.
Special Service Tool




Remover/Installer, Blower Motor, 412-140




2 Rotate the special tool clockwise to secure the blower motor assembly.
Special Service Tool




Remover/Installer, Blower Motor, 412-140
3 Install the recirculation blend door housing assembly.
Connect the recirculation blend door actuator electrical connector.
Connect the air quality sensor electrical connector.
Secure the wiring harness.
4 Install the CJB bracket.
Torque to: 10 Nm
5 Secure the wiring harnesses to the CJB bracket.
6 Install the CJB.
7 Connect the 5 electrical connectors to the CJB and secure the front carpet.
8 Install the CJB lower access cover.
9 Install the passenger side footwell duct.

10 Install the glove compartment.
For additional information, refer to Glove Compartment Service and Repair

11 Connect the blower motor electrical connector.

12 Install the accelerator pedal assembly.
For additional information, refer to Accelerator Pedal Service and Repair

13 Connect the battery ground
cable.
For additional information, refer to Specifications [1][2]Specifications