Symptom Related Diagnostic Procedures

Symptom Chart






DTC Index

Adaptive Front Lighting System (AFS) Control Module

NOTE:
If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component.

NOTE:
Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer-approved diagnostic system).

NOTE:
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.

NOTE:
Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.

NOTE:
If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.

NOTE:
Prior to installation/replacement of the Headlamp Assembly carry out all relevant internal visual and mechanical checks for correct cable location and termination including: checks for corroded, bent or backed out pins or terminals, incorrectly inserted connectors and harness damage due to chaffing or incorrect routing.

NOTE:
If the control module has been removed and reinstalled, carry out a DTC code clear, cycle the ignition state to off, then on. This will erase any DTCs that have been logged during the module installation procedure
For a complete list of all Diagnostic Trouble Codes (DTCs) that could be logged on this vehicle, please refer to Section 100-00.
For additional information, refer to Diagnostic Trouble Code (DTC) Index - DTC: Headlamp Control Module (HCM)