Electrical, A/T - Battery Cable Routing With A/T R&R

No: LTB00349 (ISSUE 1)
22 MAR 2011

SECTION: 307
Cable Routing Change When Installing New Transmission

AFFECTED VEHICLE RANGE:
LR2 (LF)
VIN: 8H000212-AH172293

Model Year:
2008 - 2010

CONDITION SUMMARY:

Situation:
As a result of changes made to the transmission casing, the positive battery and starter solenoid cables routing and securing points have been modified.

NOTE:
When replacing the transmission with a modified casing (part number LR021650 or LR023720 [or later]), the positive battery cable must be replaced with part number LR023719 (or later) and re-routed with the starter solenoid cable to the revised securing points on the transmission casing.

Action:
In the event it becomes necessary to install a new transmission (part number LR021650 or LR023720 [or later]), refer to the Repair Procedure outlined below to install a new positive battery cable and properly route it with the starter solenoid cable.

PARTS:
LR023719 Battery positive cable Qty: 1

TOOLS:
Refer to Workshop Manual for any required special tools

WARRANTY:

NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.





DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal Warranty policies and procedures apply

REPAIR PROCEDURE

REPLACE TRANSMISSION AND POSITIVE BATTERY CABLE

1. Refer to Workshop Manual, section 307-01: Automatic Transmission / Transaxle, and remove the transmission.

2. Refer to Workshop Manual, section 303-01A: Engine - 3.2L NA-16, and remove the intake manifold.





3. Disconnect the battery positive cable from the generator. (Figure 1)

4. Remove the positive battery cable.





5. Install the new positive battery cable: (Figure 2)

^ Route cable as indicated.

6. Connect the positive battery cable to the generator:
(Figure 1)

^ Tighten nut to l2Nm (8.85lbf ft).

7. Refer to Workshop Manual, section 303-01: Engine - 3.2L NA-16, and install the intake manifold.

8. Refer to Workshop Manual, section 307-01: Automatic Transmission/Transaxle, and install the transmission.