Trunk / Liftgate: Adjustments

Liftgate Alignment




1 With the liftgate closed, check the alignment of the liftgate to roof panel. The liftgate should be central in its aperture. Profile of the liftgate to roof panel should be 2 mm below flush.




2 Remove the rear headliner trim panel.
- Release the 7 clips.
- Disconnect the electrical connector.




3 Loosen, but do not remove both liftgate hinge to body bolts.
4 Position the liftgate central to the aperture.




5 Remove the LH liftgate to body bolt.
6
CAUTION: When setting the liftgate profile, make sure that the liftgate hinge NOT being adjusted has its retaining bolt fitted.
NOTE:
Turning the Allen key clockwise will raise the liftgate.
Using a 13 mm Allen key, adjust the LH liftgate hinge until a profile of 2 mm below flush to the roof panel is achieved.
- Install the bolt and tighten to 40 Nm (30 lb.ft).
7 Repeat the above procedure for the RH liftgate hinge.
8 Check for correct operation of the liftgate, and if necessary adjust the liftgate and tailgate strikers.
9 Install the rear headliner trim panel.
- Connect the electrical connector.
- Secure with the clips.