Trunk / Liftgate: Service and Repair
Liftgate
Removal
1 Open the liftgate and tailgate.
2 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
3 Remove the liftgate upper trim panel.
- Release the 4 clips.
4 Remove the liftgate side trim panel.
- Release the 5 clips.
- Repeat the above procedure for the other side.
5 Remove the rear headliner trim panel.
- Release the 7 clips.
- Disconnect the electrical connector.
6 Disconnect the washer jet hose.
- Release the grommet.
7 Release the liftgate wiring harness.
- Disconnect the 2 electrical connectors.
- Release the grommet.
8 With assistance, remove the liftgate assembly.
- Release the clips and disconnect the struts.
- Remove the 2 bolts.
Installation
1 With assistance, install the liftgate assembly.
- Tighten the bolts to 40 Nm (30 lb.ft).
- Connect the struts and secure with the clips.
2 Attach the liftgate wiring harness.
- Install the grommet.
- Connect the electrical connectors.
3 Connect the washer jet hose.
- Install the grommet.
4 Install the liftgate side trim panel.
- Secure with the clips.
- Repeat the above procedure for the other side.
5 Install the liftgate upper trim panel.
- Secure with the clips.
6 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair
7 Check and adjust the liftgate to roof panel profile. For additional information, refer to Liftgate Alignment Adjustments