Loadspace Trim Panel RH
Loadspace Trim Panel RH
Removal
1 Remove the loadspace floor panels.
- Lift and remove the front panel.
- Lift and remove the rear panel.
2 Remove the loadspace compartment anchors.
- Remove the bolt.
- Repeat the above procedure for the other anchor.
3 Remove the loadspace trim panel.
- Release the 3 clips.
4
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the 2 clips.
Installation
1 Install the clips.
2 Install the loadspace trim panel.
- Secure the clips.
- Position the locating pegs.
3 Install the loadspace compartment anchors.
- Position the locating peg.
- Tighten the bolt to 25 Nm (18 lb.ft).
- Repeat the above procedure for the other anchor.
4 Install the loadspace floor panels.