Sunroof / Moonroof Module: Service and Repair

Roof Opening Panel Module

Removal





1 Remove the rear overhead console.
- Carefully release the 9 clips.
- Disconnect the 2 electrical connectors.




2 Remove the roof opening panel module.
- Slide the module to the LH side to release it from the bracket.
- Disconnect the 2 electrical connectors.

Installation
1 Install the roof opening panel module.
- Connect the electrical connectors.
- Secure the module to the bracket.
2 Install the rear overhead console.
- Connect the electrical connectors.
- Carefully secure the clips.
3 Using T4, configure a new roof opening panel module.
4 If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panels calibration routine and reset these functions.