Front Disc Brake

Front Disc Brake

COMPONENT LOCATIONS









GENERAL
The front brakes each consist of a twin piston brake caliper, a ventilated brake disc and a dust shield. All models except 2.7L feature the same caliper, disc and dust shield.
The brake caliper is attached to the rear of the front knuckle. The brake pads are made from an asbestos free material. The inboard brake pad of the left front brake incorporates a wear sensor.
When hydraulic pressure is supplied to the caliper, the pistons extend and force the inner pad against the disc. The caliper body reacts and slides on the guide pins to bring the outer pad into contact with the disc.
The front brake pad wear sensor is connected in series with the rear brake pad wear sensor, between the instrument cluster and ground. When a brake pad incorporating a brake pad wear sensor is approximately 75% worn, the brake pad wear sensor goes open circuit. When the instrument cluster detects the open circuit, it illuminates the amber Light Emitting Diode (LED) in the brake warning indicator. Vehicles with the high line instrument cluster also display an appropriate warning in the message center and sound a warning chime. For additional information, refer to Instrument Cluster Description and Operation
At the beginning of each ignition cycle, the instrument cluster performs a bulb check on the brake warning indicator: the indicator is illuminated amber for 1.5 seconds, red for 1.5 seconds, then goes off.