Camshaft Drive Cassette RH

Camshaft Drive Cassette RH

Special Service Tools






Sprocket holding tool RH rear cassette

303-643

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Remove the RH cylinder head assembly. For additional information, refer to Cylinder Head RH Cylinder Head RH
3 Remove the torque converter flexplate. For additional information, refer to Flexplate Service and Repair




4 Remove the cylinder block jackshaft plug.
- Drift to release.




5 Using the special tool, remove the RH cassette jackshaft drive, sprocket bolt.
- Remove and discard the Torx bolt.




6 Remove the camshaft drive cassette assembly.
- Remove the bolt retaining the chain guide.
- Remove and discard the O-ring seal.




7
NOTE:
Do not disassemble further if the component is removed for access only.
Disassemble the cassette assembly.
- Release the cable tie.
- Remove the sprockets and the chain.
- Clean and inspect the components for deterioration.

Installation
1 Assemble the cassette assembly.
- Install the chain and the sprockets.
- Secure with a cable tie.
2 Install the camshaft drive cassette assembly.
- Install a new O-ring seal.
- Tighten the bolt to 12 Nm (9 lb.ft).




3 Using the special tool, tighten the new jackshaft sprocket bolt to 40 Nm (30 lb.ft), then a further 45 degrees.
4 Install the cylinder block jackshaft plug.
- Clean the component mating faces.
5 Install the torque converter flexplate. For additional information, refer to Flexplate Service and Repair
6 Install the cylinder head RH assembly. For additional information, refer to Cylinder Head RH Cylinder Head RH
7 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair