Climate Control Assembly

Climate Control Assembly
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.

NOTE:
Make sure that the gear selector lever is in position N before removing any components.
For additional information, refer to Floor Console Upper Section Floor Console Upper Section

Torque to: 2.5 Nm

CAUTION: When installing the lower locating tang of the trim panel, make sure the floor console is not damaged. If necessary protect the surrounding areas using masking tape.

NOTE:
LHD illustration shown, RHD is similar.

NOTE:
Remove in the sequence shown.

NOTE:
To install, reverse the removal sequence.

CAUTION: When installing the lower locating tang of the trim panel, make sure the floor console is not damaged. If necessary protect the surrounding areas using masking tape.

NOTE:
Remove in the sequence shown.

NOTE:
To install, reverse the removal sequence.

Torque to: 2.5 Nm

Installation

NOTE:
Make sure that all the clips are correctly installed.
1 To install, reverse the removal procedure.