Operation CHARM: Car repair manuals for everyone.

Accelerator Pedal: Service and Repair






Accelerator Pedal

Removal





1 Remove the driver side closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.




2 Remove the accelerator pedal assembly.
- Release the wiring harness.
- Remove the 3 nuts.
- Disconnect the electrical connector.




3
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the accelerator pedal bracket.
- Remove the 3 nuts and bolts.

Installation

All vehicles
1 Attach the accelerator pedal bracket.
- Tighten the nuts and bolts to 10 Nm (7 lb.ft).
2
NOTE:
Make sure the electrical connector is securely connected.
Install the accelerator pedal assembly.
- Connect the electrical connector.
- Tighten the nuts to 25 Nm (18 lb.ft).
- Secure the wiring harness.
3 Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.

Vehicles with petrol engine
4 Using the approved diagnostic equipment, clear the powertrain control module (PCM) adaptations.