Actuator: Service and Repair

Differential Locking Motor

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.




2 Remove the differential locking motor.
- Disconnect the electrical connector.
- Remove the 4 bolts.

Installation
1 Clean the component mating faces.




2 Apply continuous bead of sealant to the motor mating face on the differential.
3 Install the differential locking motor.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Connect the electrical connector.
4 Lower the vehicle.
5 Calibrate the differential locking motor using the diagnostic tool.