Front Wheel Speed Sensor

Front Wheel Speed Sensor

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the fender splash shield. For additional information, refer to Fender Splash Shield Fender Splash Shield




3 Release the brake hose bracket from the wheel knuckle.
- Remove the retaining bolt.




4
CAUTION: Do not allow the brake caliper to hang on the brake hose.
Release the brake caliper anchor plate from the wheel knuckle and tie the caliper aside.
- Remove the two retaining bolts.




5 Release the wheel speed sensor from the wheel knuckle.
- Remove the bolt.




6 Remove the wheel speed sensor.
- Disconnect the electrical connector.
- Release the wiring harness from the 5 clips.

Installation
1 Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
2
NOTE:
Make sure the electrical connector retaining clip is attached to the body wiring harness.
Install the wheel speed sensor.
- Connect the electrical connector.
- Attach the wiring harness to the 5 clips.
- Tighten the bolt to 9 Nm (7 lb.ft).
3 Secure the brake caliper and anchor plate to the wheel knuckle.
- Tighten the bolts to 275 Nm (203 lb.ft).
4 Secure the brake hose retaining bracket to the wheel knuckle.
- Tighten the bolt to 25 Nm (18 lb.ft).
5 Install the fender splash shield. For additional information, refer to Fender Splash Shield Fender Splash Shield
6 Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
7 Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
8 If a new wheel speed sensor has been installed, interrogate the ABS system using T4.