Rear Wheel Speed Sensor

Rear Wheel Speed Sensor

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the wheel and tire.




3 Disconnect the anti-lock brake system (ABS) sensor electrical connector.
- Release the wiring harness retaining clip.




4 Release the wheel speed sensor from the wheel knuckle.
- Release the wiring harness.
- Remove the retaining bolt.




5 Remove the wheel speed sensor.
- Release the wiring harness from the 4 clips.

Installation
1 Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
2 Install the wheel speed sensor.
- Attach the wiring harness to the 4 clips.
3 Secure the wheel speed sensor to the wheel knuckle.
- Tighten the bolt to 9 Nm (7 lb.ft).
- Attach the wiring harness to the clip.
4
NOTE:
Make sure the electrical connector retaining clip is attached to the body wiring harness.
Connect the ABS sensor electrical connector.
- Attach the wiring harness.
5 If a new wheel speed sensor has been installed, interrogate the ABS system using T4.