Steering Angle Sensor: Service and Repair

Steering Angle Sensor

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair




2 Remove the driver side closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.




3 Disconnect the steering angle sensor electrical connector.




4 Disconnect the steering column intermediate shaft from the steering column.
- Note the fitted position.
- Remove the special bolt and discard the nut.




5 Remove the steering angle sensor.
- Remove the 3 Torx screws.

Installation
1 Install the steering angle sensor.
- Tighten the Torx screws to 3 Nm (2 lb.ft).
2 Connect the steering column intermediate shaft.
- Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
3 Connect the steering angle sensor electrical connector.
4 Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.
5 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair
6 Initiate a new steering angle sensor using T4.