Selector Lever Assembly

Selector Lever Assembly

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.




2 If installed, remove the transmission undershield.
- Remove the 6 bolts.




3 Remove the transmission heat shield.
- Remove the 4 bolts.




4 Release the selector cable.
- Using an additional wrench, restrain the clamping bush and loosen the locknut.
- Compress the latch and release the cable.




5 Release the selector cable from its guide bracket.
6 Remove the floor console upper trim panel.




7 Remove the transmission selector lever.
- Remove the 3 nuts.
- Disconnect the electrical connector.
- Release the selector cable from the body.

Installation
1 Install the transmission selector lever.
- Secure the cable to the floor.
- Connect the electrical connector.
- Tighten the nuts to 8 Nm (6 lb.ft). Before VIN257100, discard old fixings.
2
NOTE:
Do not tighten the locking nut at this stage.
Connect the selector cable to the transmission.
- Engage the inner cable with the lever clamping bush.
- Connect the selector cable to its abutment bracket.
3 Position the selector cable to its guide bracket.
4 Install the floor console upper trim panel.
5 Adjust the selector cable.
6 Install the transmission heat shield.
- Tighten the bolts to 10 Nm (8 lb.ft).
7 If installed, install the transmission undershield.
- Tighten the bolts to 10 Nm (8 lb.ft).