Front Seat

Front Seat

Removal

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
1 Make the SRS system safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices




2
NOTE:
Torx bolts may be re-used.
Release the front seat.
- Remove the bolt covers.
- Remove and the 5 Torx bolts.




3 Release the safety belt lower anchor from the seat.
- Remove the bolt cover.
- Passenger side, disconnect the electrical connector.
- Remove and discard the Torx bolt.




4 With assistance, remove the front seat.
- Protect the rocker panel.
- Remove the bolt.
- Disconnect the 2 electrical connectors.
- Release the 2 wiring harness clips.

Installation
1 With assistance, install the front seat.
- Connect the electrical connectors.
- Secure the wiring harness clips.
2 Attach the safety belt lower anchor to the seat.
- Tighten the new Torx bolt to 40 Nm (30 lb.ft).
- Passenger side, connect the electrical connector.
- Install the bolt cover.
3 Secure the front seat.
- Tighten the Torx bolts to 40 Nm (30 lb.ft).
- Install the bolt covers.
4 Connect the battery ground cable.