Ignition Switch Lock Cylinder: Service and Repair

Ignition Lock Cylinder

Removal

NOTE:
This procedure is for removal and installation of the ignition lock cylinder. The ignition lock and door lock cylinders are replaced in sets.
1 Fully extend the steering column for access.




2 Remove the steering column upper shroud.
- Release the 4 clips.




3 Remove the steering column lower shroud.
- Remove the 3 Torx screws.
- Release the steering column adjustment lever.
4 Remove the passive coil.
- Disconnect the electrical connector.
- Release the 2 clips.




5 Remove the ignition lock cylinder.
- Turn the ignition key to position 1.
- Insert a pin, not exceeding 2 mm diameter, through the access hole in the ignition lock cylinder housing to depress the plunger, and release the ignition lock cylinder.

Installation





1 Install the ignition lock cylinder.
- Turn the ignition key to position 1.
- Locate into guides and depress the plunger.
2 Install the passive coil.
- Secure the clips.
- Connect the electrical connector.
3 Install the steering column shrouds.
- Tighten the Torx screws.
- Secure the clips.
- Secure the adjustment lever.