Air Bag Control Module: Service and Repair

Restraints Control Module (RCM)

Removal

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

NOTE:
If the restraints control module (RCM) is to be replaced then T4 must be connected and the correct procedures adhered to, prior to battery disconnection.

NOTE:
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Make the SRS system safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
3 Remove the floor console. For additional information, refer to Floor Console




4
CAUTION: Make sure the wiring harness is protected when cutting the carpet.
Remove the restraints control module (RCM).
- Cut the carpet for access.
- Disconnect the 2 electrical connectors.
- Remove the 3 Torx screws.

Installation
1 Install the RCM.
- Tighten the Torx screws to 10 Nm (7 lb.ft).
- Connect the electrical connectors.
- Position the carpet.
2 Install the floor console. For additional information, refer to Floor Console
3 Initiate a new RCM using T4.