Installation

Transmission
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures


NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.

NOTE:
Some illustrations may show the transmission removed for clarity.

NOTE:
Some illustrations may show the engine removed for clarity.





CAUTION: Apply grease of the correct specification to the torque converter spigot.

CAUTION: Make sure the torque converter remains connected to the transmission.
1 With assistance, install the transmission.





Torque to: 40 Nm





Torque to: 10 Nm





Torque to: 10 Nm





















Torque to: 3 Nm





Torque to: 9 Nm





NOTE:
RHD illustration shown, LHD is similar.













Torque to: 9 Nm





NOTE:
RHD illustration shown, LHD is similar.





WARNING: Be prepared to collect escaping fluids.
Install new O-ring seals.
Torque to: 12 Nm

















Torque to: 10 Nm





WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.





Torque to: 10 Nm





Torque to: 10 Nm





Torque to: 9 Nm




M6 Bolt: 10 Nm
M6 Nut: 12 Nm





Torque to: 8 Nm









CAUTION: Only rotate the crankshaft clockwise.
2 Make sure that the alignment mark is visible through the inspection hole on install of the first torque converter bolt.
Torque to: 63 Nm
For additional information, refer to Front Driveshaft - 5.0L Front Driveshaft
For additional information, refer to Exhaust System Service and Repair
For additional information, refer to Rear Driveshaft Rear Driveshaft
For additional information, refer to Axle Assembly Front Drive Axle/Differential

WARNING: Make sure to support the vehicle with axle stands.
3 Lower the vehicle.
4 Install the battery.
For additional information, refer to Battery Removal and Replacement