Fender: Service and Repair

Fender
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
2 Remove the front bumper cover.
For additional information, refer to Front Bumper Cover

CAUTION: Mark the components to aid installation.

Installation
1 Install the screw retainers.
2 Install the fender edge finisher.
3 Install the fender air intake grille.

NOTE:
Make sure that these components are installed to the noted removal position.
4 Install the front fender.
Torque to: 5 Nm

NOTE:
Make sure that these components are installed to the noted removal position.
5 Install the fender lower moulding.
6 Install the bumper cover retaining bracket.
7 Install the front bumper cover.
For additional information, refer to Front Bumper Cover