Radiator Cooling Fan: Service and Repair

Cooling Fan
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.

CAUTION: After switching off the ignition, wait for 2 minutes before disconnecting the battery. Failure to wait for 2 minutes will damage the navigation computer.
2 Disconnect the battery ground cable.
For additional information, refer to Specifications Specifications
3 Remove the intake manifold.
For additional information, refer to Intake Manifold Service and Repair




4 Release the A/C and power steering pipes.
5 Remove the A/C line support bracket.




6 Remove the A/C compressor, lower support bracket.




7 Remove the A/C compressor, upper support bracket.




8 Using suitable tools, release the accessory drive belt tension.




9 Release the A/C compressor and position aside.





10 Disconnect the cooling fan control electrical connector.

11 Release the cooling fan wiring harness.





12 Remove the cooling fan assembly.

Installation
1 Install the cooling fan assembly.
2 Install the A/C compressor.
Torque to: 25 Nm
3 Install the A/C compressor, upper support bracket.
M10: 45 Nm
M8: 25 Nm
M6: 10 Nm
4 Install the accessory drive belt.
5 Install the A/C compressor, lower support bracket.
Torque to: 25 Nm
6 Install the A/C line support bracket.
Torque to: 10 Nm
7 Secure the A/C pipes.
8 Secure the cooling fan harness.
9 Connect the cooling fan electrical connector.

10 Install the intake manifold.
For additional information, refer to Intake Manifold Service and Repair

11 Connect the battery ground cable.
For additional information, refer to Specifications Specifications