Removal and Replacement

Accessory Drive Belt
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal
1 Remove the engine cover.
For additional information, refer to Engine Cover - 3.2L Service and Repair
2 Remove the battery tray.
For additional information, refer to Battery Tray Service and Repair
3 Remove the air cleaner assembly.
For additional information, refer to Air Cleaner Service and Repair




4 Remove the A/C compressor, upper support bracket.




5 Remove the A/C compressor, lower support bracket.




6 Using suitable tools, release the accessory drive belt tension.




7 Release the A/C compressor and position aside.





CAUTION: Note the fitted position of the component prior to removal.
8 Release the PAS pump.
9 Remove the accessory drive belt.

Installation





1 Install the accessory drive belt.

NOTE:
Make sure that the component is installed to the position noted on removal.
2 Install the PAS pump.
Torque to: 25 Nm
3 Install the A/C compressor.
Torque to: 25 Nm
4 Install the accessory drive belt.
5 Install the A/C compressor, lower support bracket.
Torque to: 25 Nm
6 Install the A/C compressor, upper support bracket.
M10: 45 Nm
M8: 25 Nm
M6: 10 Nm
7 Install the air cleaner assembly.
For additional information, refer to Air Cleaner Service and Repair
8 Install the battery tray.
For additional information, refer to Battery Tray Service and Repair
9 Install the engine cover.
For additional information, refer to Engine Cover - 3.2L Service and Repair