Air Bag Control Module: Service and Repair

Restraints Control Module (RCM)
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
The RCM must be replaced after every time any SRS component has been deployed.
1 Make the SRS system safe.
For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Remove the floor console.
For additional information, refer to Floor Console Floor Console




Cut the carpet for access.
Position the carpet aside for access.

Torque to: 10 Nm

Installation
1 To install, reverse the removal procedure.
2 Using Land Rover approved diagnostic equipment, programme a new RCM.