Control Module: Service and Repair

Transmission Control Module (TCM)
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
2 Remove the cover and disconnect the battery ground cable.
For additional information, refer to Specifications Specifications
3 Remove the A/C compressor mounting bracket.
For additional information, refer to Accessory Drive Component Bracket Service and Repair




4 Release and disconnect the selector lever cable.




5 Release the support bracket.




6 Remove the transmission selector lever.





Installation
1 Install the TCM.
Torque to: 24 Nm
2 Install the transmission selector lever.
Torque to: 13 Nm
3 Secure and connect the selector lever cable.
4 Install the support bracket.
Torque to: 25 Nm
5 Install the A/C compressor mounting bracket.
For additional information, refer to Accessory Drive Component Bracket Service and Repair
6 Connect the battery ground cable and install the cover.
For additional information, refer to Specifications Specifications
7 If a new component has been installed, configure using Land Rover approved diagnostic equipment.