Ignition Switch: Service and Repair

Ignition Switch
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal
1 Make the SRS system safe.
For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Remove the driver lower air bag module.
For additional information, refer to Driver Lower Air Bag Module Driver Lower Air Bag Module





NOTE:
RHD illustration shown, LHD is similar.
3 Remove the keyless start control module trim cover.




4 Remove the steering column lower cowl.
5 Adjust the steering column to its lowest position.









NOTE:
Take extra care when releasing the clips.
6 Remove the instrument cluster surround.




7 Remove the ignition switch.

Installation
1 To install, reverse the removal procedure.