Body - Liftgate Finisher Repair Process
LTB00436NAS113 FEB 2012
SECTION: 501
Liftgate Finisher Repair Process
AFFECTED VEHICLE RANGE:
LR2 (LF)
VIN: BH216517 - CH277723
Model Year:
2011 - 2012
CONDITION SUMMARY:
Situation:
The liftgate outer surface beneath the lower edge corners of the liftgate finisher may become scratched. This may be caused by lack of clearance between the liftgate surface and the liftgate finisher lower edge causing contact and abrasion.
Action:
In the event of a customer concern of the above, refer to the Repair Procedure outlined below to perform a modification to the liftgate finisher.
PARTS:
LR002238 Buffer Qty: 2
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal Warranty policies and procedures apply
REPAIR PROCEDURE
FINISHER LIFTGATE UPPER MODIFICATION
1. Refer to Workshop Manual, section 501-03: Power Liftgate Switch, and perform steps 1-2 only.
2. Inspect for paint damage on the liftgate where the liftgate finisher is located:
^ If damage is evident, rectify as necessary as a separate claim.
^ If no damage is evident, continue to step 3.
NOTE:
Make sure the liftgate trim finisher surface is clean and free from dirt.
3. Install the two self adhesive buffers on the liftgate lift trim
4. Refer to Workshop Manual, section 501-03: Power Liftgate Switch, and perform steps 2-1 only.
Disclaimer