Power Transfer Unit

Power Transfer Unit
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1 Raise and support the vehicle.
For additional information, refer to Driveshaft - Vehicles Without: Diesel Particulate Filter (DPF) Service and Repair
For additional information, refer to Catalytic Converter Service and Repair
For additional information, refer to Front Halfshaft RH Front Halfshaft RH





Torque to: 65 Nm









NOTE:
This step requires the aid of another technician.

Torque to: 60 Nm





Torque to: 10 Nm

Installation
1 To install, reverse the removal procedure.





CAUTION: Make sure that the component is clean, free of foreign material and lubricant.

NOTE:
Apply the required quantity of grease the correct specification.
For additional information, refer to Specifications Mechanical Specifications