Front Door Window Regulator: Service and Repair

Front Door Window Regulator and Motor
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
If possible, lower the window glass by approximately one third of its travel.
1 Disconnect the battery ground cable.
For additional information, refer to Specifications Specifications
2 Remove the front door speaker.
For additional information, refer to Front Door Speaker Front Door Speaker




3 Carefully remove the outer waist seal.




4 Release the door window glass from the window lift mechanism. Raise the glass and secure it to the top of the door frame.
Special Service Tool




Release Lever, Door Glass, 501-114




5 Remove the glass guide channel.




6 Remove the front door control module.




7 Remove the window motor and regulator assembly.

Installation
1 Install the window motor and regulator assembly. Tighten the nuts and the bolts.
Torque to: 10 Nm
2 Install the door control module.
3 Install the glass guide channel and lining. Tighten the bolt.
Torque to: 10 Nm
4 Secure the door window glass to the window lift mechanism.
5 Install the outer waist seal and secure with the Torx screw.
6 Install the front door speaker.
For additional information, refer to Front Door Speaker Front Door Speaker
7 Connect the battery ground cable.
For additional information, refer to Specifications Specifications