Rear Door Window Regulator: Service and Repair

Rear Door Window Regulator and Motor
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
If possible, lower the window glass by approximately one third of its travel.
1 Disconnect the battery ground cable.
For additional information, refer to Specifications Specifications
2 Remove the rear door module.
For additional information, refer to Rear Door Module (RDM) Rear Door Module (RDM)




3 Carefully remove the outer waist seal.




Release the door window glass from the window lift mechanism. Raise the glass and secure it to the top of the door frame.
Special Service Tool




Release Lever, Door Glass, 501-114




4 Secure the glass to the top of the frame.




Remove the window motor and regulator assembly.
Rotate the assembly within the door through 90 degrees and remove the upper edge from the aperture first.

Installation
1 Install the window motor and regulator assembly. Tighten the nuts and the bolts.
Torque to: 10 Nm
2 Secure the door window glass to the window lift mechanism.
3 Install the outer waist seal and secure with the Torx screw.
4 Install the rear door module.
For additional information, refer to Rear Door Module (RDM) Rear Door Module (RDM)
5 Connect the battery ground cable.
For additional information, refer to Specifications Specifications