Rear Window Wiper Pivot Arm

Rear Window Wiper Pivot Arm
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.





CAUTION: Make sure that these components are installed to the noted removal position.
Release the cover.
Loosen, but do not remove the nut.
Using the special tool, release the rear window wiper pivot arm.
Special Service Tool




Puller, General Purpose, 303-D121
1 Remove the rear window wiper pivot arm nut.
Torque to: 7 Nm




2 Remove the rear window wiper pivot arm.





NOTE:
Do not disassemble further if the component is removed for access only.
3 Remove the rear window wiper blade.

Installation






CAUTION: Make sure that the component aligns with the installation mark.
1 To install, reverse the removal procedure.