Front Parking Aid Camera Wiring Harness - Front Section

Front Parking Aid Camera Wiring Harness - Front Section

Removal

CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
1 Remove the central junction box (CJB). For additional information, refer to Central Junction Box (CJB) Central Junction Box (CJB)




2
NOTE:
The left hand front camera wiring harness connectors are colored magenta, the right hand front camera wiring harness connectors are colored blue.
Disconnect the electrical connector.
3 Remove the battery. For additional information, refer to Battery Removal and Replacement




4 Remove the battery compartment side wall.
- Release the battery positive cable and grommet.
- Release the 4 clips.




5 Release the engine compartment fuse box.
- Remove the bolt.




6 Remove the brake master cylinder cover.
7 Remove the air cleaner.For additional information, refer to Air Cleaner




8 Release the hood seal.




9 Release the wiring harness carrier.
- Remove the 4 nuts.





10 Release the 3 clips.





11
NOTE:
The left hand front camera wiring harness connectors are colored white, the right hand front camera wiring harness connectors are colored green.
Disconnect the electrical connector.

Installation





1
CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
Install the camera overlay wiring harness




2
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
Remove the connector from the camera overlay wiring harness.
- Remove the locking tab.
- Carefully release the clip.
- Apply suitable tape to protect the end of the camera overlay wiring harness.




3 Using suitable tape, secure a suitable rod to the camera overlay wiring harness.




4 Carefully feed the camera overlay wiring harness under the bracket.




5 Carefully feed the camera overlay wiring harness through the wiring harness carrier.




6 Carefully feed the camera overlay wiring harness through the wiring harness carrier.




7 Using a suitable tool, make a hole in grommet in the position shown.




8 With the aid of another technician, carefully feed the camera overlay wiring harness through the grommet.




9
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
Install the connector to the camera overlay wiring harness.
- Remove the protective tape.
- Install the electrical connector.
- Secure the locking tab.





10
NOTE:
The left hand front camera wiring harness connectors are colored magenta, the right hand front camera wiring harness connectors are colored blue.
Connect the electrical connector.





11
NOTE:
The left hand front camera wiring harness connectors are colored white, the right hand front camera wiring harness connectors are colored green.
Connect the electrical connector.

12
CAUTION: Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the harness.
Using suitable tie straps, secure the camera overlay wiring harness to the main body wiring harness.





13 Secure the 3 clips.





14 Secure the wiring harness carrier.
- Tighten the 4 nuts.





15 Secure the engine compartment fuse box.
- Tighten the bolt.





16 Install the battery compartment side wall.
- Secure the 4 clips.
- Install the battery positive cable and grommet.

17 Install the air cleaner. For additional information, refer to Air Cleaner





18 Install the brake master cylinder cover.

19 Secure the hood seal.

20 Install the CJB. For additional information, refer to Central Junction Box (CJB) Central Junction Box (CJB)

21 Install the battery. For additional information, refer to Battery Removal and Replacement