Rear Parking Aid Camera Wiring Harness - Liftgate Section

Rear Parking Aid Camera Wiring Harness - Liftgate Section

Removal

CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.




1 Remove the rear headliner trim panel.
- Release the 7 clips.
- Disconnect the electrical connector.




2 Disconnect the electrical connector.
3 Remove the liftgate lower trim panel. For additional information, refer to Liftgate Trim Panel Liftgate Trim Panel




4 Remove the liftgate upper trim panel.
- Release the 4 clips.




5 Remove the liftgate side trim panel.
- Release the 5 clips.




6 Disconnect the electrical connector.




7 Release the liftgate conduit.

Installation





1
CAUTION: Make sure that the camera overlay wiring harness is not bent excessively during this procedure. Failure to follow this instruction may result in damage to the harness.
Install the camera overlay wiring harness.




2
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
Remove the electrical connector from the camera overlay wiring harness.
- Align the camera wiring harness tang with the electrical connector clip.
- Carefully release the clip.
- Apply suitable tape to protect the end of the camera overlay wiring harness.




3 Using suitable tape, secure a suitable rod to the camera overlay wiring harness.




4 Carefully feed the camera overlay wiring harness though the conduit.




5
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
Install the connector to the camera overlay wiring harness.
- Remove the protective tape.
- Align the camera wiring harness tang with the electrical connector clip.
- Install the electrical connector.




6 Connect the electrical connector.
7
CAUTION: Make sure that excessive force is not used when installing the tie straps to the wiring harness. Failure to follow this instruction may result in damage to the vehicle.
Using suitable tie straps, secure the camera overlay wiring harness to the tailgate harness.




8 Connect the electrical connector.




9 Secure the liftgate conduit.





10 Install the liftgate side trim panel.
- Secure the 5 clips.





11 Install the liftgate upper trim panel.
- Secure the 4 clips.

12 Install the liftgate lower trim panel. For additional information, refer to Liftgate Trim Panel Liftgate Trim Panel

13 Install the rear headliner trim panel.
- Connect the electrical connector.
- Secure the 7 clips.