Operation CHARM: Car repair manuals for everyone.

Fender: Service and Repair





Fender

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications Specifications
2 Remove the plenum chamber panel. For additional information, refer to Plenum Chamber Service and Repair
3 Remove the headlamp assembly. For additional information, refer to Headlamp Assembly Service and Repair
4 Remove the fender splash shield. For additional information, refer to Fender Splash Shield Fender Splash Shield
5 Remove the fender moulding. For additional information, refer to Fender Moulding




6 Remove the fender lower moulding.
- Release the 4 clips.




7 Remove the fender air intake grille.
- Release the 4 clips.
- Remove the air ducting.




8 Remove the front fender.
- Remove the 6 Torx bolts.
- Remove the nut.




9
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the fender rear trim.
- Remove the 3 clips.

Installation
1 Install the fender rear trim.
- Secure in the 3 clips.
2 Install the front fender.
- Install the bolts and tighten to 10 Nm (7 lb.ft).
- Install the nut and tighten to 10 Nm (7 lb.ft)
3 Install the fender air intake grille.
- Install the air ducting.
4 Install the lower fender moulding.
- Secure in the clips.
5 Install the fender moulding. For additional information, refer to Fender Moulding
6 Install the fender splash shield. For additional information, refer to Fender Splash Shield Fender Splash Shield
7 Install the headlamp assembly. For additional information, refer to Headlamp Assembly Service and Repair
8 Install the plenum chamber panel. For additional information, refer to Plenum Chamber Service and Repair
9 Connect the battery ground cable. For additional information, refer to Specifications Specifications