Front Seat

Seat Track

Removal

NOTE:
The front seat track motor is supplied as part of the front seat lower frame assembly.
1 Remove the front seat. For additional information, refer to Front Seat Front Seat




2 Remove the front seat cushion side trim.
- Remove the 2 Torx screws.
- Release from the 4 clips.




3 Release the seat control switch.
- Remove the 2 screws.
- Remove the 2 clips.




4 Remove the front seat base trim.
- Remove the screw.
- Release the 2 clips.




5 Remove the front seat base.
- Remove the 6 nuts.




6 Remove the front seat track motor.
- Disconnect the electrical connector.
- Release the electrical connector.
- Remove the 8 nuts.




7 Remove the front seat track motor assembly from the seat rails.
- Remove the 4 bolts.
- Release the flexi drive from the seat rails.

Installation





1 Make sure the seat rails are installed as a matched pair as supplied.
- Make sure the seat rails are correctly aligned.
2 Install the front seat track motor assembly to the seat rails.
- Install the 4 bolts.
- Tighten the nuts to 10 Nm (7 lb.ft).
3 Install the front seat track motor.
- Tighten the nuts to 22 Nm (16 lb.ft).
- Connect the electrical connector.
- Secure the electrical connector.
4 Install the front seat base.
- Tighten the nuts to 22 Nm (16 lb.ft).
5 Install the front seat base trim.
- Secure in the clips.
- Tighten the screw.
6 Install the front seat cushion side trim.
- Secure in the clips.
- Tighten the screws.
7 Install the seat control switch.
- Secure in the clips.
- Tighten the screws.
8 Install the front seat. For additional information, refer to Front Seat Front Seat