Fender Splash Shield

Fender Splash Shield

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the fender moulding. For additional information, refer to Fender Moulding




3 Remove the fender splash shield.
- Remove the 2 screws.
- Remove the 6 retainers.
- Disconnect the electrical connector.




4
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the tire pressure antenna.
- Remove the 2 retainers.

Installation
1 Install the tire pressure antenna.
- Install the retainers.
2 Install the fender splash shield.
- Connect the electrical connector.
- Install the retainers.
- Install the screws.
3 Install the fender moulding. For additional information, refer to Fender Moulding