Engine Wiring Harness

Engine Wiring Harness

Removal

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.

All vehicles
1
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2 For additional information, refer to Specifications Specifications
3 For additional information, refer to Auxiliary Battery Tray Auxiliary Battery Tray
4 For additional information, refer to Battery Tray Battery Tray
5 For additional information, refer to Air Cleaner Outlet Pipe LH Air Cleaner Outlet Pipe LH
6 For additional information, refer to Air Cleaner Outlet Pipe RH Air Cleaner Outlet Pipe RH
7 For additional information, refer to Plenum Chamber Service and Repair
8 For additional information, refer to Exhaust System Service and Repair

9
NOTE:
Remove and discard the gasket.
TORQUE: 48 Nm

10
NOTE:
Remove and discard the gasket.
TORQUE: 48 Nm

12
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
CAUTION: Be prepared to collect escaping fuel.

13
NOTE:
RHD illustration shown, LHD is similar.

16
NOTE:
Make sure the electrical connector is correctly secured.

Vehicles without supercharger

17

Vehicles with supercharger

18

All vehicles

21 TORQUE: 10 Nm

27 TORQUE: 10 Nm

30 TORQUE: 6 Nm

32 TORQUE: 10 Nm

33
NOTE:
RHD illustration shown, LHD is similar.
TORQUE: 47 Nm Nm

34
NOTE:
RHD illustration shown, LHD is similar.
TORQUE: 47 Nm Nm

39 TORQUE: 48 Nm

44 TORQUE: 10 Nm

45 TORQUE: 10 Nm

46 TORQUE: 10 Nm

47 TORQUE: 10 Nm

49
NOTE:
RHD illustration shown, LHD is similar.

Installation
1
NOTE:
After the engine harness has been installed, test using Land Rover/ Jaguar approved diagnostic equipment.
To install, reverse the removal procedure.