Tail Lamp: Service and Repair

Rear Lamp Assembly

Removal
1 Open the liftgate and tailgate.




2
CAUTION: Always protect paintwork and glass when removing exterior components.
Remove the rear lamp assembly.
- Remove the 2 screws.
- Release the 2 clips.
- Disconnect the electrical connector.




3
NOTE:
Do not disassemble further if the component is removed for access only.
NOTE:
Note the fitted position.
Remove the wiring harness.
- Release the wiring harness from the 2 clips.
- Release the 6 bulb holders.
- Release the electrical connector.

Installation
1 Install the wiring harness.
- Install the 6 bulb holders.
- Install the electrical connector.
- Secure the wiring harness in the clips.
2 Install the rear lamp assembly.
- Connect the electrical connector.
- Secure with the 2 clips.
- Tighten the screws.
3 Close the tailgates.