Inspection and Verification

Inspection and Verification

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.
1 Verify the customer complaint. As much information as possible should be gathered from the driver to assist in diagnosing the cause(s). Confirm which of the following two warning types (A or B) exist for the Tire Pressure Monitoring System when the ignition status is switched from 'OFF' to 'ON'
- (A) Check Tire Pressure Warnings. A low tire pressure warning will continuously illuminate the low tire pressure warning lamp. This warning may be accompanied by a text message such as CHECK TIRE PRESSURE (refer to owner literature). The manufacturer approved diagnostic system does NOT need to be used. Diagnostic Trouble Codes (DTCs) are not generated with this type of warning. To extinguish this warning it is essential that, with the ignition 'ON', all vehicle tires (including the spare) are to be set to the correct pressure as stated in the vehicle handbook or as indicated on the placard label in the passenger/driver door aperture. It is not necessary to drive the vehicle to clear 'check tire pressure' warnings - just changing the tire pressure causes the tire low pressure sensor to transmit new data.

NOTE:
The tire pressures should be set by:
- Using a calibrated tire pressure gauge
- With 'cold' tires (vehicle parked in the ambient temperature for at least one hour, not in a garage with an artificial ambient temperature)

NOTE:
If the tire pressure warning does not clear within two minutes, it is likely that the gauge is not correctly calibrated or the tires are 'warm'. Carry out the following steps until the warning has cleared:
- Rotate wheels approximately 180 degrees
- Increase the tire pressures by 3psi
- Wait a further two minutes
- When the tires are at ambient temperature and a calibrated gauge is available, reset the tire pressures to the correct pressure.

NOTE:
Tire pressure adjustments are part of routine owner maintenance. Tire pressure adjustments that are required due to a lack of owner maintenance are not to be claimed under vehicle warranty.
(B) System Fault Warnings. When a system fault is detected, the low tire pressure warning lamp will flash for approximately 75 seconds prior to being continuously illuminated. Visually inspect wheel arch Tire Pressure Monitoring System Antennas and check for system DTCs. External visual damage to the tire low pressure sensors and air leaks will not cause system fault warnings (note: nut and seal system should be replaced at each tire change using the available service kit). Check for the presence of tire low pressure sensors on all four wheels (note: a tire low pressure sensor has a metal valve stem rather than a rubber one).
2 Check for Diagnostic Trouble Codes (DTCs) and refer to the DTC Index.


DTC Index
For a list of Diagnostic Trouble Codes (DTCs) that could be logged on this vehicle, please refer to Section 100-00. For additional information, refer to Diagnostic Trouble Code (DTC) Index - DTC: Central Junction Box (CJB) Central Junction Box (CJB)