Ride Height Sensor: Service and Repair

Suspension Height Sensor

Removal

NOTE:
This procedure covers removal and installation of both the front and rear suspension height sensors.

NOTE:
The right hand sensor has a black colored lever and the left hand sensor has a white colored lever.
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.




2
CAUTION: Do not use excessive force to disconnect the height sensor link.
Remove the suspension height sensor.
- Disconnect the height sensor link.
- Disconnect the electrical connector.
- Remove the 2 Torx screws.

Installation
1
CAUTION: Make sure the Torx screw is not over tightened. Failure to follow this instruction will result in damage to the vehicle.
To install, reverse the removal procedure.
- Tighten the screws to 3 Nm (2 lb.ft).
2 Using Land Rover approved diagnostic equipment, calibrate the ride height.