Alarm Module: Service and Repair

Passive Anti-Theft System (PATS) Module

Removal

NOTE:
When a new passive anti-theft system (PATS) module is to be installed, the Land Rover approved diagnostic system must be connected to the vehicle and the PATS renewal procedure must be followed. This will allow vehicle configuration to be uploaded into the new PATS module.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 Remove the instrument panel center speaker. For additional information, refer to Instrument Panel Speaker Instrument Panel Speaker




3 Release the passive anti-theft system (PATS) module.
- Disconnect the passive anti-theft system (PATS) electrical connector.




4 Remove the PATS module.

Installation
1 Install the PATS module.
- Connect the PATS module electrical connector.
2 Secure the PATS module.
3 Install the instrument panel center speaker. For additional information, refer to Instrument Panel Speaker Instrument Panel Speaker
4 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
5
NOTE:
Only carry out the following step if a new PATS module is to be installed.
Using the Land Rover approved diagnostic system, calibrate a new PATS module.