Portable Camera Docking Station

Portable Camera Docking Station

Removal

WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.

WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

WARNING: The correct procedures must always be used when working on SRS components.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

WARNING: Take extra care when handling SRS components.
1 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
3 Remove the upper glove compartment. For additional information, refer to Upper Glove Compartment Upper Glove Compartment




4 Release and remove the portable camera from the portable camera docking station.




5 Remove the portable camera docking station.
- Remove the 2 screws.

Installation
1 Install the portable camera docking station.
- Install the screws and tighten to 2 Nm (2 lb.ft).
2 Install the portable camera to the portable camera docking station.
3 Install the upper glove compartment. For additional information, refer to Upper Glove Compartment Upper Glove Compartment
4 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System