Navigation System: Service and Repair

Navigation System Digital Versatile Disc (DVD) Unit

Removal
1
CAUTION: After switching off the ignition, wait for 2 minutes before disconnecting the battery. Failure to wait for 2 minutes will damage the navigation computer.
Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 Remove the access panel from the loadspace trim panel LH.




3 Release the navigation system digital versatile disc (DVD) unit.




4 Remove the navigation DVD unit.
- Disconnect the coaxial cable connector.
- Disconnect the 2 electrical connectors.

Installation
1 Install the navigation DVD unit.
- Connect the coaxial cable connector.
- Connect the electrical connectors.
2 Secure the navigation DVD unit.
- Tighten the bolts to 4 Nm (3 lb.ft).
3 Install the access panel to the loadspace trim panel LH.
4 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
5 Using the Land Rover approved diagnostic equipment, follow the on-screen instructions and configure the navigation DVD unit.