Lumbar Assembly

Lumbar Assembly

Removal

WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.

WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

WARNING: The correct procedures must always be used when working on SRS components.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

WARNING: Take extra care when handling SRS components.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Battery and Charging System
2 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
3 Remove the front seat backrest lower rear cover. For additional information, refer to Front Seat Backrest Lower Rear Cover Front Seat Backrest Lower Rear Cover




4 Reposition the front seat backrest heater and blower motor assembly.
- Carefully release the 2 clips.




5 Reposition the front seat backrest heater and blower motor assembly duct.
- Release the 2 clips.




6 Reposition the lumbar motor control valve.
- Disconnect the 2 electrical connectors.




7 Remove the lumbar assembly.
- Release the 2 retaining tangs.

Installation
1
NOTE:
Make sure the lumbar assembly is installed to its original position.
Install the lumbar assembly.
- Secure the 2 retaining tangs.
2 Reposition the lumbar motor control valve.
- Connect the 2 electrical connectors.
3 Reposition the front seat backrest heater and blower motor assembly duct.
- Secure the 2 clips.
4 Reposition the front seat backrest heater and blower motor assembly.
- Secure the 2 clips.
5 Install the front seat backrest lower rear cover. For additional information, refer to Front Seat Backrest Lower Rear Cover Front Seat Backrest Lower Rear Cover
6 Connect the battery ground cable. For additional information, refer to Specifications Battery and Charging System